| FLYiNG 零件編號 | ICEC93C46ANM1GRECMOS |
| FLYiNG 庫存現貨 | 10 |
| 製造商 | E-CMOS |
| 製造商零件編號 | EC93C46ANM1GR |
| 說明 | EEPROM EC93C46ANM1GR SOP-8 E-CMOS |
| 無鉛狀態 / RoHS 指令狀態 | RoHS |
| 訂購數量 | NTD 單價 / PCS |
| 1~9 | 17 |
| 10~99 | 16 |
| 類別 | EEPROM 電子抹除式可複寫唯讀記憶體 |
| 製造商 | E-CMOS |
| 記憶體類型 | 非揮發性 |
| 原廠料號 | EC93C46ANM1GR |
| 記憶體尺寸 | 128×8 |
| 時脈週期 | 250/1000/2000 KHz |
| 寫入週期時間 | 5ms(max) |
| 電源電壓 | 1.7~5.5V |
| 工作溫度 | -40~85°C |
| 安裝類型 | SMD 表面黏著式 |
| 封裝／外殼 | SOP-8 |
文件:EC93C46A.png)
EC93C46A Three-wire Serial EEPROM
General Description
The EC93C46A provides 1024 bits of serial electrically erasable programmable read only memory (EEPROM) organized as 64 words of 16 bits each, when the ORG pin is connected to VCC and 128 words of 8 bits each when it is tied to ground. The EC93C46A is available in spacesaving PDIP-8, SOP-8, TSSOP-8, MSOP-8, and DFN-8 packages. The EC93C46A is enabled through the Chip Select pin (CS), and accessed via a 3-wire serial interface consisting of Data Input (DI), Data Output (DO), and Shift Clock (SK) signals. Upon receiving a Read instruction at DI, the address is decoded and the data is clocked out serially on the data output pin DO. The WRITE cycle is completely self-timed and no separate erase cycle is required before write. The Write cycle is only enabled when it is in the Erase/Write Enable state. When CS is brought “high” following the initiation of a write cycle, the DO pin outputs the Ready/Busy status.
Features
EC93C46A 三線串行 EEPROM
一般說明
EC93C46A 提供 1024 位串行電可擦除可編程只讀存儲器 (EEPROM)，當 ORG 引腳連接到 VCC 時，每個 16 位的 64 個字和接地時每個 8 位的 128 個字組成。 EC93C46A 採用節省空間的 PDIP-8、SOP-8、TSSOP-8、MSOP-8 和 DFN-8 封裝。 EC93C46A 通過片選引腳 (CS) 啟用，並通過由數據輸入 (DI)、數據輸出 (DO) 和移位時鐘 (SK) 信號組成的 3 線串行接口訪問。在 DI 接收到讀指令後，地址被解碼，數據在數據輸出引腳 DO 上串行輸出。 WRITE 週期是完全自定時的，在寫入之前不需要單獨的擦除週期。寫週期僅在它處於擦除/寫使能狀態時才被使能。當寫週期開始後 CS 變為“高”時，DO 引腳輸出就緒/忙碌狀態。
特徵
EC93C46A Three-wire Serial EEPROM
General Description
The EC93C46A provides 1024 bits of serial electrically erasable programmable read only memory (EEPROM) organized as 64 words of 16 bits each, when the ORG pin is connected to VCC and 128 words of 8 bits each when it is tied to ground. The EC93C46A is available in spacesaving PDIP-8, SOP-8, TSSOP-8, MSOP-8, and DFN-8 packages. The EC93C46A is enabled through the Chip Select pin (CS), and accessed via a 3-wire serial interface consisting of Data Input (DI), Data Output (DO), and Shift Clock (SK) signals. Upon receiving a Read instruction at DI, the address is decoded and the data is clocked out serially on the data output pin DO. The WRITE cycle is completely self-timed and no separate erase cycle is required before write. The Write cycle is only enabled when it is in the Erase/Write Enable state. When CS is brought “high” following the initiation of a write cycle, the DO pin outputs the Ready/Busy status.
Features
- Low-voltage Operation
- - 1.7V (Vcc = 1.7V to 5.5V)
- Three-wire Serial Interface
- 2 MHz Clock Rate(5V) Compatibility
- Self-timed Write Cycle (5 ms max)
- High-reliability
- - Endurance: 1 Million Write Cycles
- - Data Retention: 100 Years
- PDIP-8, SOP-8, TSSOP-8, MSOP-8, and DFN-8 packages.
EC93C46A 三線串行 EEPROM
一般說明
EC93C46A 提供 1024 位串行電可擦除可編程只讀存儲器 (EEPROM)，當 ORG 引腳連接到 VCC 時，每個 16 位的 64 個字和接地時每個 8 位的 128 個字組成。 EC93C46A 採用節省空間的 PDIP-8、SOP-8、TSSOP-8、MSOP-8 和 DFN-8 封裝。 EC93C46A 通過片選引腳 (CS) 啟用，並通過由數據輸入 (DI)、數據輸出 (DO) 和移位時鐘 (SK) 信號組成的 3 線串行接口訪問。在 DI 接收到讀指令後，地址被解碼，數據在數據輸出引腳 DO 上串行輸出。 WRITE 週期是完全自定時的，在寫入之前不需要單獨的擦除週期。寫週期僅在它處於擦除/寫使能狀態時才被使能。當寫週期開始後 CS 變為“高”時，DO 引腳輸出就緒/忙碌狀態。
特徵
- 低壓運行
- - 1.7V（Vcc = 1.7V 至 5.5V）
- 三線串行接口
- 2 MHz 時鐘速率 (5V) 兼容性
- 自定時寫週期（最大 5 ms）
- 高可靠性
- - 耐久性：100 萬次寫入周期
- - 數據保留：100 年
- PDIP-8、SOP-8、TSSOP-8、MSOP-8 和 DFN-8 封裝。
